TEREX C4000 recall: Pintle hitch plate bending
Terex C4000, C6000, General 65 and TC55 vehicles may have an incorrectly installed pintle hitch that can bend the rear bumper hitch plate; the manufacturer plans a free inspection, hitch replacement and bracing work.
Owners of the listed Terex vehicles should be aware of a hitch installation issue that can affect the rear mounting area. If the hitch fails, trailer control may be lost, raising the risk of a crash.
What the official recall record says
TEREX: C4000, C6000, GENERAL 65 and other models
The affected vehicles may have a pintle hitch installed without the reinforced bracing intended for that setup. That can allow the rear bumper hitch plate to bend and may lead to hitch failure, with a resulting loss of trailer control. The manufacturer plans to inspect the hitch, replace it and add bracing; a damaged bumper is to be replaced as needed, at no charge.
Owner information from the official record
- Owner notices: Owner notification letters are expected to be mailed October 16, 2026.
- Manufacturer contact: Owners may contact Ring Power’s customer service at 904-613-0035.
- Manufacturer recall reference: 23402
Official record
- NHTSA recall ID: 26V639000
- Vehicles listed: TEREX C4000 (2022, 2021, 2020); TEREX C6000 (2021, 2020); TEREX GENERAL 65 (2020); TEREX TC55 (2022, 2021, 2020)
- Potentially affected: 100
- Components: TRAILER HITCHES
- Report received: October 2, 2026
- Owner notification: Owner notification letters are expected to be mailed October 16, 2026.
- Defect: Ring Power Corporation (Ring Power) is recalling certain 2020 Terex General 65, 2020-2021 C6000, 2020-2022 C4000, and TC55 vehicles. The incorrect pintle hitch may have been installed without reinforced bracing, resulting in the rear bumper hitch plate bending.
- Safety consequence: The pintle hitch may fail, causing a loss of trailer control and increasing the risk of a crash.
- Remedy: Ring Power will inspect, replace the pintle hitch, and install bracing. Damaged bumpers will be replaced. All repairs will be performed free of charge. Owner notification letters are expected to be mailed October 16, 2026. Owners may contact Ring Power’s customer service at 904-613-0035. Ring Power’s number for this recall is 23402.
What owners should do next
Use the manufacturer and authorized dealer contact information provided with this campaign to discuss the planned inspection and repair.
A headline cannot confirm whether a particular vehicle is affected. Use the official NHTSA recall lookup with the vehicle identification number and contact the manufacturer or an authorized dealer for vehicle-specific guidance.
Related RecallWire reporting
Need a fuller vehicle history?
VINsmart offers paid vehicle-history reports. For current recall status and no-cost repair eligibility, use NHTSA or your vehicle manufacturer.
Advertisement — RecallWire may earn a commission if you purchase a VINsmart report through this link.
Sources used for this report.
References checked October 9, 2026.
National Highway Traffic Safety Administration. Safety Recall Report: Campaign 26V639000. Report received October 2, 2026. Accessed October 9, 2026.
To check a specific vehicle, use the official NHTSA VIN recall lookup.
TEREX C4000 recall: Plate weld may crack
Terex C4000, C5000, C6000 and General 65 digger derrick trucks may have a plate weld that can crack and allow a retaining pin to separate; the weldment plate will be inspected and replaced as needed at no charge.